PRODUCTS

HBX 1:8 NITRO CARS
HBX 1/8th Scale Truggy
HBX 1/8th Scale Buggy
HBX 1/8th Scale Buggy PRO

ACME-TECH
FULLY BUILT NITRO CARS
Off Road Nitro Buggy
PRO Off Road Nitro Buggy
Off Road Nitro Buggy SE
On Road Nitro Car
On Road Nitro Car PRO
Off Road Nitro Truck
Off Road Nitro Truck SE
Mini Nitro Buggy
Mini Nitro Truggy

NITROTEK
FULLY BUILT NITRO CARS
Rally Nitro Cars
PRO Rally Nitro Cars
Nitro Monster Truck
Nitro Monster Truck PRO

UNBUILT NITRO CARS
Unbuilt Nitro Buggy
Unbuilt Nitro Monster Truck
Unbuilt Nitro Car

1:5 PETROL CARS
XRC 1/5th Scale Car
XRC 1/5th Scale Buggy
SQ 1/5th Scale Monster Truck

ENTRY / INTERMEDIATE
ELECTRIC CARS
Spy Rc Car
Off Road Electric Rc Buggy
Off Road Electric Rc Truck
On Road Electric Rc Car

INTERMEDIATE
ELECTRIC CARS
Rally RC Cars
Monster Truck

TOP OF THE RANGE
ELECTRIC RC CARS
Electric RC Buggy
Electric RC Truggy

MINI MONSTERS
Mini Nitro Buggy
Mini Nitro Truggy
Mini Electric Buggy
Mini Electric Truggy

ELECTRIC RC HELICOPTERS
2ch Laser Battle Apaches
3ch Micro RC Helicopter
3ch Entry Twin Blade
Walkera 5#6 Micro Heli
4ch Twin Blade Apache
4ch Twin Blade Lama
4ch Twin Blade Comanche
4ch RC Helicopter
6ch CP2 RC Helicopter
6ch King 2 RC Helicopter
6ch Belt-CP Brushless Heli

ENTRY LEVEL RC PLANES
2ch Trainer Plane
3ch Wing Dragon
RC Glider

4 CH MID RC PLANES
Wing Dragon Sportster
Zero Warbird
P-51D Warbird

NITRO / ELECTRIC RC BOATS
Tiger Shark Rc Boats (Nitro)
Atlantic Yacht Rc Boats (Electric)
Volvo Rc Boats (Electric)

RC BB TANKS
1/24 Entry Level Rc Tank
1/16 Mid Level Rc Tank
1/16 Pro BB Smoking Tank

RC ROBOTS
RC Robot Man
RC Robot Dinosaur

MISC.
Accessories
Engines
Engine Parts
Upgrades & Hop Ups
Spare Parts
Used or Reduced items

View Shopping Basket

Before Using A Nitro Car

Before using any nitro model it is important that you check the following:

* Receiver Battery
* Range check (Stand a distance away from the model and make sure it is responding to the radio control correctly. Ideally do this with someone else so you can stand as far away as you want to use the model.
* Radio Battery
* Glow Plug is tight and glow start is fully charged
* Ensure engine flywheel is tight and tighten if needed (IMPORTANT OR THE FLYWHEEL WILL WEAR AWAY)
* Loctite/tighten any loose nuts, screws or bolts. ie: set screws, engine mount screws, wheel nuts, etc
* Clutch-bell and Spur Gear mesh (IMPORTANT OR YOU WILL STRIP YOUR GEARS)
* Pullstart engine screws
* Nylon ties for exhaust
* Clean & Re-Oil or replace Foam Air Filter element
* Ensure all servo & throttle linkage is straight at 90 degrees & in proper alignment when the radio equipment is turned on. Adjust if needed.
* Ensure fuel system is free of obstruction, line pinches, dirt & leaks
* Clean entire car after every tank - watch for sand, rocks, mud, debris or anything that will hinder proper operation and maintenance.

The above maintenance should be observed ideally after every run.

The main adjustment screw would have been pre-set at the factory and we would have double checked it to make sure it is correct for running the engine in. In 99% of cases this screw will not need touching until after you have run the engine in if you wish to fine tune it. If you do loose the starting position of the screw or want to check it then the top of the screw should be just 1 - 2 mm below the top of the screw casing.