PRODUCTS
HBX
1:8 NITRO CARS
ACME-TECH
FULLY BUILT NITRO CARS
NITROTEK
FULLY BUILT NITRO CARS
UNBUILT
NITRO CARS
1:5 PETROL CARS
ENTRY
/ INTERMEDIATE
ELECTRIC CARS
INTERMEDIATE
ELECTRIC CARS
TOP
OF THE RANGE
ELECTRIC RC CARS
MINI MONSTERS
ELECTRIC
RC HELICOPTERS
ENTRY LEVEL RC PLANES
4 CH MID RC PLANES
NITRO / ELECTRIC RC BOATS
RC BB TANKS
RC
ROBOTS
MISC.
|
How Does The Controller Work?
Install 4 "AA" batteries in the receiver
pack on the car. Next install 8 "AA" batteries in the
transmitter. When installing the batteries be careful not to push
the metal conector tabs on the controller down causing a bad contact.
If you do this just pull them back up with a screw driver.
Turn on the radio system and check that all servos are working correctly.
Check all the linkages to make sure they are not binding. Always
remember, the transmitter is the first to be tuned on and the last
to be turned off. Never turn off the radio when the engine is running.
To stall the engine you can either run it out of gas or cover the
exhaust hole. The switch on the car only turns off the electronics
in the car, not the engine.
Always make sure the batteries in both your car and your radio are
strong or fully charged. Attempting to run your car with weak batteries
will make the car not respond to users controls. It could even completely
become uncontrollable and become a "runaway car" and severely
damage the car.
Check the wires from your battery and your antenna wire every few
runs. These wires could become damaged and result in loss of control.
Before starting the engine, always check the range of the transmitter
before running the car. Short range can be the result of a broken
antenna wire or weak batteries.
BUTTONS ON THE CONTROLLER
The Rev switches:
These reverse the direction the servo moves when you pull the trigger
or turn the wheel. If when you turn the wheel right the car turns
left then flip the St Rev switch to correct this. If the brake comes
on when you pull the trigger flip the Th Rev switch to correct this.
The Trims:
Your controller will have two dials or sliders. These are used to
align the controls. If for example when you are driving the car
pulls to one side you can use the steering trim to line it up so
it drives straight. You can use the throttle trim if when you turn
the radio on the servo opens the throttle or applies the brake to
put it back to neutral.
|
INFORMATION
COMPANY
INFO
RESOURCES
WHOLESALE
CUSTOMERS
Nitrotek
European Sites
We
are listed on ,
,
,
,
,
and many more.
|
View Shopping Basket ..
